Pneumatic nailer for C6 series...
Pneumatic nailer for C6 series mini-micro brads and P6 series mini pins. ZT Line.
Suitable brads and pins lengths: 15-18-22-25-30-35-40-45 mm.
Pneumatic nailer firing both C6 series brads and P6 series pins (having wire size 0.6 mm).
The nailer is supplied in a plastic carrying case together with an oiler and lubricating fluid, a ¼” male nipple for quick coupler “Germany type”, and descriptive technical documentation.
Tool features: by turning the knurled knob placed on the tool side, it is possible to adjust the driving depth of the fastener on the surface to be fixed.
Contact safety lever, identifiable with the nose, for a better firing positioning and for safety locking when the magazine of the nailer is empty, in order to avoid dry firing and subsequent breakage of the bumper.
A protective rubber pad on the nose prevents the nailer from denting worktop.
The exhaust air outlet is placed in the handle of the pneumatic tool.
Mode of operation: connect the nailer to a source of compressed air at an operating pressure of 5 ÷ 6.5 bar; pull the specific lever to open the magazine and then pull back the sliding magazine. Insert a strip of brads or pins, so that their tips be in contact with the base of the magazine and their heads be in the specific groove. If the brad or pin do not fit in the magazine, it means that the length is wrong and they must be replaced with the proper ones. Otherwise, close the sliding magazine and the nail gun is ready for use.
|Pressione di Esercizio (bar)||5-6,5|
|Sezione Filo (mm)||0.64|